The Grandeur Super Auto Clutch

The most revolutionary clutch product in the V-twin industry

Installation instructions for 3" BDL open Primary Drives


1.
Remove adjuster screw by first loosening jam nut then back allen bolt completely out.

The Grandeur Super Auto Clutch

2.
Remove Shoulder bolts & springs.

The Grandeur Super Auto Clutch

3.
Discard pressure plate.

The Grandeur Super Auto Clutch

4.
Remove ALL clutch disc and plates. Remove six outer drive dowels (which is every other one) six will be left in place.

The Grandeur Super Auto Clutch

5.
Install six new supplied dowels in the spaces where you just removed the original six.

The Grandeur Super Auto Clutch

7.

Reinstall clutch disc and plates as follows: 1 - Thick Plate; 2 - Disc (these are the ones with fiber); 3 - Thin Plate; 4 - Disc; 5 - Thin Plate; 6 - Disc; 7 - Thin Plate; 8 - Disc; 9 - Thin Plate; 10- Disc; 11 - Thin Plate; 12 - Disc; 13 - Thin Plate; 14 - Disc; 15 - Supplied Plate; 16 - Disc.

You must follow this order and finish with a fiber disc last (against pressure plate). If you do not have enough travel (.070-.100) replace supplied plate step 15 with the original thin plate and then repeat steps 8 & 9.


The Grandeur Super Auto Clutch

8.
Install new pressure plate assembly using supplied 8-32 socket head screws, use supplied threadlocker on screw threads. At this point check for proper clearance by pushing in on center of pressure plate. You should have .070-.100 of movement.

The Grandeur Super Auto Clutch


9.
Install adjuster bolt and jam nut. Adjust clutch for proper free travel. Run adjuster in until it just touches. Then back it out TWO full turns. This is a good starting point. Clutches typically adjust properly between 1 1/2 and 3 turns.

The Grandeur Super Auto Clutch