trickstuff1.jpg

The Grandeur Super Auto Clutch
The most revolutionary clutch product in the V-twin industry.
Installation instructions for 3" BDL open Primary Drives

1. Remove adjuster screw by first loosening jam
nut then back allen bolt completely out.

2. Remove Shoulder bolts & springs.

3. Discard pressure plate..

4. Remove ALL clutch disc and plates.
5. Remove six outer drive dowels (which is every other one) six will be left in place.

6. Install six new supplied dowels in the spaces where you just removed the original six. .

7. Reinstall clutch disc and plates as follows:...

1. Thick plate	9. Thin plate
2. Disc (these are the ones with fiber)	10.Disc
3. Thin plate	11.Thin plate
4. Disc	12.Disc
5. Thin plate	13.Thin Plate
6. Disc	14.Disc
7. Thin plate	15.Supplied plate
8. Disc	16.Disc

You must follow this order and finish with a fiber disc last (against pressure plate)

8. Install new pressure plate assembly using
supplied 8-32 socket head screws, use supplied threadlocker on screw threads.

If you do not have enough travel (.070-.100)
Do the following :
Replace supplied plate step 15 with the original thin plate and then repeat steps 8 & 9.

At this point check for proper clearance by pushing in on center of pressure plate. You should have
.070-.100 of movement.

9. Install adjuster bolt and jam nut. Adjust clutch for proper free travel. Run adjuster in until it just touches. Then back it out TWO full turns. This is a good starting point. Clutches typically adjust properly between 1 1/2 and 3 turns.

Back Out Two Turns